Resideo s8910U3000 Flame Detector
Technical specs, application notes, replacement checks, and related model references.
Product Overview
The Resideo s8910U3000 is an advanced Intermittent Pilot or Direct Spark Ignition (DSI) control module, built on decades of trusted Honeywell engineering. It provides fully automated ignition sequence, flame monitoring, and system shutoff for gas-fired commercial boilers, furnaces, and heating appliances. Equipped with comprehensive diagnostic LED indicators and robust environmental protection, this module ensures rapid troubleshooting and uninterrupted burner operation in demanding industrial HVAC environments.
Technical Specifications
Control Voltage
24 V AC (60 Hz)
Ignition Type
Direct Spark / Intermittent Pilot
Pre-purge Time
Configurable / Model Specific
Flame Failure Response Time
0.8 seconds (max)
Ambient Temperature
-40°F to +175°F (-40°C to +79°C)
Selection Notes & Data Verification
The s8910U3000 page is structured for engineering comparison: confirm the product type, firing range, fuel type, operating mode, electrical supply, and safety approvals against the manufacturer datasheet before specifying the burner or component.
Burner.wiki normalizes product data for discovery and comparison, but final selection should account for combustion chamber backpressure, local emission limits, control sequence requirements, and site commissioning conditions.
Typical Applications
Related Models
Related Knowledge
FAQ
What is Resideo s8910U3000 used for?
Resideo s8910U3000 is referenced as a flame detector for industrial combustion systems. Verify the exact application against the burner documentation, control cabinet wiring, and manufacturer datasheet.
Can s8910U3000 replace another model?
Replacement depends on voltage, safety timing, wiring terminals, flame supervision method, mechanical fit, and local combustion safety requirements.
What should be checked before installing s8910U3000?
Check supply voltage, burner sequence, fuel type, pressure or capacity range, detector compatibility, safety loop configuration, and the equipment nameplate before commissioning.
Documentation Note
Technical documentation should be verified against the manufacturer datasheet, burner cabinet wiring diagram, and equipment nameplate before installation or replacement.
- Check supply voltage and frequency.
- Confirm terminal layout and safety interlocks.
- Verify flame detector or actuator compatibility.
Need Engineering Help?
Our experts can help you verify if s8910U3000 fits your combustion chamber and backpressure requirements.
Contact Engineering